 |
| |
Reg. 534, Reg. 534 A,
Reg. 534 B
STANDARD CONDITIONS FOR THE DESIGN AND
CONSTRUCTION
OF ECONOMISER, FEED PIPES, FEED HEATERS AND OTHER SIMILAR
VESSELS
REGULATIONS FOR REGISTRATION AND INSPECTION OF ECONOMISERS
AND FEED PIPES
Engraving of registry number |
|
a)
|
Every economiser
shall have a plate with its registry number engraved,
secured in a conspicuous place and wherever practicable
stamped for identification with that number in a prominent
place. |
| b) |
A letter “E”
shall be refixed to the registry number in the denominator
of the appropriate device as shown in Regulation
382.
Example:-
|
|
| |
Reg. 534 A
STANDARD CONDITIONS FOR THE DESIGN AND
CONSTRUCTION
OF ECONOMISER, FEED PIPES, FEED HEATERS AND OTHER SIMILAR
VESSELS
REGULATIONS FOR REGISTRATION AND INSPECTION OF ECONOMISERS
AND FEED PIPES
Inspection of Feed Pipes |
| |
|
a)
|
Feed pipes shall
be inspected and hydraulically tested before erection
in place, and the hydraulic test pressure shall be not
less than twice the working pressure of the economiser.
A certificate from the recognized maker or Inspecting
Authority that this has been done may be accepted. If
the Inspector is satisfied with the test, the pipes may
be erected. No separate certificate for feed pipes shall
be issued, nor shall a separate fee be charged for their
inspection. The engraving shall be done within a
period of two months from the date of receipt of the registry
number. |
| b) |
At subsequent inspection
or at any other time, the Inspector may make an external
Inspection of feed pipes and if found in any unsatisfactory
condition he shall report the matter to the Chief Inspector
who may require the pipes to be hydraulically tested. |
| c) |
The engraving
shall be completed and ready for verification
within thirty days from the date of receipt of the
engraving slip from the Chief Inspector of the State. |
| d) |
Economisers having
registry devices different from those prescribed
in clause (a) and (b) shall have such devices crossed
out or erased and engraved a new in conformity
with those prescribed in the clauses aforesaid.
The original numbers of such economisers shall be
retained in the new device provided that incase of
economisers operating in an area which consequent upon
the reorganisation of state forms part of another state,
new numbers shall be given by the Chief Inspector of the
State. A number once allotted shall not be used
again in another economiser. |
|
| |
Reg. 534 B
STANDARD CONDITIONS FOR THE DESIGN AND
CONSTRUCTION
OF ECONOMISER, FEED PIPES, FEED HEATERS AND OTHER SIMILAR
VESSELS
REGULATIONS FOR REGISTRATION AND INSPECTION OF ECONOMISERS
AND FEED PIPES
Submission of plans of Feed Pipes |
| |
|
| a) |
The fees for the scrutiny
of plans and particulars of the material, design
and construction of feed pipes, before commencement
of manufacture of the feed pipes shall be at the
rate of Rs. 30 for 30 metres of piping or part thereof,
subject to a minimum of Rs. 50, inclusive of all
fittings excepting fittings like feed water heaters.
For any such fittings like feed water heater, the
fee shall be equal to the registration fee of the
boiler to which feed pipe is attached subject to
a maximum of Rs.1500. |
| b) |
The fees for scrutiny
of lay-out plans of feed pipes shall be Rs. 20 for
30 metres of piping or part thereof, subject to
a minimum of Rs.50, exclusive of fittings like feed
water heater for any such fittings like feed water
heater, the fee shall be Rs. 150.00 for each such
fittings.”. |
|
|
|
|
|
|
|
