| |
Reg. 395, Reg. 395 A
Submission of plans of steam-pipes
|
a)
|
Plans of steam pipes shall be submitted
with the prescribed fee to the Chief Inspector before
construction or at the time of registration of the boiler
for his decision whether the pipes and their arrangement
comply with the Regulations. |
| b) |
| (i) |
The fees for examination
of plans and the particulars of materials, design
and construction of steam pipes before the commencement
of manufacture of the steam pipes shall be at the
rate of Rs. 30/- for 30 meters of piping or part
thereof, subject to a minimum of Rs.50/-, inclusive
of all fittings excepting the fittings like de-superheaters,
steam receivers, feed heaters and separately fired
superheaters. For any fittings like de-superheaters,
steam receivers, separators and flanges, the fee
shall be Rs.150.00 for each category of such identical
fittings. |
| ii) |
The fees for examination
of lay out plans of steam pipes shall be Rs.20/-
per 30 metres of piping or part thereof, subject
to a minimum of Rs.50/-, inclusive of all fittings,
except fittings like de-superheaters steam receivers,
feed heaters and separately fired superheaters.
For any fittings like de-superheaters, steam receivers
and separators, the fee shall be Rs.150.00 for each
such fittings. |
|
Reg. 395 A
Inspection fee for boilers and parts thereof constructed
in India
|
1)
|
The inspection fee for boilers shall be
calculated on the following basis:
| (i) |
at four times the registration
fee for a boiler of riveted construction. |
| ii) |
at four times the registration
fee for a boiler of welded construction. |
|
| 2) |
Fees for inspections of boiler scantlings
shall be charged as under:-
| (i) |
upto 10 square feet (0.929
sq. meter) of outside surface - nil. |
| ii) |
above 10 square feet
(0.929 sq. meter) of outside surface – one
half of the registration fee of the boiler for which
the part is intended. |
|
| 3) |
For inspection of tubes and pipes, the
fees shall be charged at the rate of Rs.150/- per metric
tonne or a fraction thereof. |
| 4) |
Fees for inspection of boiler at the site
of construction shall be charged at the rate of four times
the registration fee.”. |
| 5) |
For inspection of forged pipe fittings,
the fees shall be charged at the rate specified for forged
and cast flanges under clause (1), of sub-regulation (2)
of regulation
395 C. |
| 6) |
For inspection of pipe fittings other than
forged pipe fittings, the fees shall be charged as under:-
| (a) Upto and including 50mm, for 100
kg. or a fraction thereof |
Rs. 50/- |
| (b) Over 50 mm and upto and including
100 mm for 450 kg. or fraction thereof. |
Rs. 250/- |
| c) Over 100 mm for 900 kg. or a fraction
thereof. |
Rs. 500/- |
|
|
